tigers
[Top] [All Lists]

Re: Edelbrock Water Pump Hub

To: Larry Paulick <larry.p@erols.com>
Subject: Re: Edelbrock Water Pump Hub
From: Steve Laifman <SLaifman@SoCal.RR.com>
Date: Sat, 05 May 2001 11:57:43 -0700
Larry Paulick wrote:
> 
> Henry, I did this on another water pump, and if the shaft is positioned so
> that the engine side of the shaft can rest on a surface, and the body of the
> water pump can rotate, then the hub can be pressed on without ruining the
> seal.
> Larry

Edelbrock makes an aluminum high flow "shorty" model, #8847, for the
HiPo first Mustangs. This is the model covered in the TigersUnited
article previously mentioned. It is also available polished, for a
goodly sum extra.
--
Steve Laifman        < Find out what is most    >
B9472289              < important in your life     >
                               < and don't let it get away!>
<SLaifman@SoCal.RR.com>
<http://www.TigersUnited.com/gallery/SteveLaifman.asp>

_/_/_/_/_/_/_/
     _/                 _/_/_/       _/_/_/       _/
    _/        _/      _/     _/     _/    _/     _/_/_/_/
   _/        _/       _/    _/      _/  _/      _/
  _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
                          _/
                     _/_/_/

<Prev in Thread] Current Thread [Next in Thread>