In a message dated 10/27/01 5:37:30 PM Eastern Daylight Time,
jimboynton@mediaone.net writes:
> Has anyone replaced reverse lockout bar on their shifter? I have a section
> snap off on the left side and would like to replace the bar. A good winter
> afternoon job in a heated garage. Is it a difficult task?
I'd say it is moderately difficult because the wire cable that connects the
t-handle to the detent on the bottom of the shifter is brazed to the bottom.
Removal requires unbrazing the wire end, pulling it out the top and then
reassembly - either brazing or as someone recommended drilling/threading a
hole in the bottom of the shifter and usign an allen screw to fasten the
cable. If you have a torch, not too bad. If you don't very difficult.
Rob K
Melbourne Fl
|