Tim, great job. Very nice addition to add some hp to the car.
Larry
Ronak, TP (Timothy) wrote:
> Listers,
> Finally got my Ram Air box done and I was lucky enough to have Photographer
> Dave (Wacky Dave I guess) snap some photos at a cruise night and post them
> on the web.
> You can see the car and the Ram air system at:
> http://wackydave.fotki.com/cruise_nights/04-01-03_tuesday/page2.html
> <http://wackydave.fotki.com/cruise_nights/04-01-03_tuesday/page2.html>
> about half way down the page.
> If you look at the back side of the hood you can see the pieces used to
> "flatten" the sealing surface. I am still searching for some soft foam for
> the front edge to seal to the hood but I am being picky I already have
> something that works I just want something that look nicer. I am going to
> try softseal and see if they have something attractive.
> I have templates and am trying to decide how to do this. I may be able to
> get pieces laser cut and bent but it costs $100 to get them welded up by an
> expert or $65 by a not so expert. I used the expert and the welds are
> beautiful.
> I do not know how much it will cost to get the pieces cut but I do know
> there is a minimum run of 25 needed so those interested give me a shout and
> I will see what I can do. It is set up for the LAT Hood RPM performer
> manifold and a Holley 650/750 DP. I have the stock K&N replacement filter in
> there now but have room to run one about half an inch taller and 14 inches
> in diameter. I will try to get one this week.
> Not sure if it is any faster but I plan to get to the Carlsbad dragway to
> try it out soon. I will also be at the Knotts berry Farm Fabulous Fords
> forever show on April 27th if you want a closer look.
>
>
> Best Regards,
>
> Tim Ronak
> Business Development Manager
> Akzo Nobel Coatings
> Off: (949) 305-5393
> Fx: (425) 955-6268
> Cell: (949) 289-3357
> email: timothy.ronak@akzonobel.com
> VM: (800) 234-6747 ext. 2257#
>
> This message, including attachments, is confidential and may be privileged.
> If you are not an intended recipient, please notify the sender then delete
> and destroy the original message and all copies. You should not copy,
> forward and/or disclose this message, in whole or in part, without
> permission of the sender.
>
#################################################################
#################################################################
#################################################################
#####
#####
#####
#################################################################
#################################################################
#################################################################
|