Might be your original rivets, but not mine! I don't doubt for a minute that
these are true, but they are not the same as on mine.. I'll go burn some film
this afternoon and take a couple of pix and post them on my site for what is
original on my MK I
mayf
----- Original Message -----
From: CJ Richards
To: DrMayf
Cc: Tom Brandt ; Steve Laifman ; Tom Witt ; tigers@autox.team.net
Sent: Friday, June 13, 2003 8:49 AM
Subject: Re: "Original Rivets" Thread - $.02
Here is the url for a picture of original rivits.......
http://www.cjrichards.org/tac.html
Chris in Arcata
DrMayf wrote:
Ok ont he Alpine 260! Bummer, I thought I had a rare one.... When I did take
the Alpine Vin plate off it did have some peaky little pop rivets, but they
were not like the ones on the tiger. I will take a pix for reference...I
need to take some more of the race car to show the gray primer I have put on
it. One more coat and a light sanding and the first color coat goes
on...Russo (or Rosso) Red, a Ford color, natch...
mayf
----- Original Message -----
From: "Tom Brandt" <tbrandt@cox-internet.com>
To: "DrMayf" <drmayf@teknett.com>; "Steve Laifman" <SLaifman@socal.rr.com>;
"Tom Witt" <wittsend@jps.net>
Cc: <tigers@autox.team.net>
Sent: Thursday, June 12, 2003 4:29 PM
Subject: Re: "Original Rivets" Thread - $.02
I just went to the garage and looked at B9470099. She has JAL plate with
the
correct(?) flat headed, slotted screws. Both the stamped nr plate, and the
spec plate have the same, very small rivets with small holes in the center
which do not go all the way through.
Also the spec plate say's Alpine 260 on the bottom line.
Tom
B9470099
|