Hi all,
Here are some links to pictures of my trunk lid support setup:
Overview:
http://members.shaw.ca/tsmit/trunk/DSC00219.JPG
Top view:
http://members.shaw.ca/tsmit/trunk/DSC00220.JPG
Trunk lid bracket:
http://members.shaw.ca/tsmit/trunk/DSC00217.JPG
Trunk opening (body) bracket:
http://members.shaw.ca/tsmit/trunk/REARSUPP.jpg
In this (blurry) picture, the forward hole location corresponds to the
original pivot location (i.e., that's where the cutout in the side cover
panel is). If the strut arm was about 1" shorter than it is, everything
would line up on the stock pivot location.
Be careful where you drill holes:
http://members.shaw.ca/tsmit/trunk/HOSEHOLE.jpg
Best regards,
Theo
|
