Group,
I just changed my plugs last night and in doing so bumped the duck bill on
the firewall and it dumped a BUNCH of water all over my hand. They were new
replacements and I had to slit them to get them open but they still are too
tight and will not drain. I am probably going to put a small wood dowel in
there to hold it slightly open. I suspect that with the new restoration you
replaced these and they are not letting the water out easily. Every time I
wash my car the floor gets wet and it is frustrating but I think I found the
problem. Perhaps check yours ... right above the #8 spark plug.
Best Regards,
Tim Ronak
Business Development Manager
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Off: (949) 305-5393
Fx: (425) 955-6268
Cell: (949) 289-3357
email: timothy.ronak@akzonobel.com
VM: (800) 234-6747 ext. 2257#
This message, including attachments, is confidential and may be privileged.
If you are not an intended recipient, please notify the sender then delete
and destroy the original message and all copies. You should not copy,
forward and/or disclose this message, in whole or in part, without
permission of the sender.
|