tigers
[Top] [All Lists]

Re: Subaru Master

To: "Ronak, TP \(Timothy\)" <Timothy.Ronak@crna.akzonobel.com>
Subject: Re: Subaru Master
From: Larry Paulick <lpaulick@comcast.net>
Date: Wed, 07 Dec 2005 08:17:59 -0500
Tim, I went with Wilwood front and rear caliber's, and made my own 
brackets.  Honda rotors on rear.  Used Wilwood spot ebrake.

Larry

Ronak, TP (Timothy) wrote:

>Listers,
>Dale A. Has suggested to use the 1981 Subaru Master Cylinder with a
>13/16 inch bore. Has anyone else done this and did they have a source
>(brand and part number) that could supply them with the reservoir. Has
>anyone else used a different master with good success? I am looking into
>using Mustang rear calipers and the kit dale sells to upgrade to vented
>rotors in the front. I do not want a race car braking system just
>something a little better than stock.
>Anyone have some input or photos of their master setup.
>I have checked into the Fiat rear calipers but they are hard to find $$$
>and the mustang version may create a lower cost alternative. Dale has
>indicated he might consider a mustang rear kit.
>
>Best Regards,
>
>Tim Ronak
>Business Development Manager
>Akzo Nobel Coatings
>23961 Via El Rocio
>Mission Viejo, CA   92691
>Off: (949) 305-5393
>Fx: (425) 955-6268
>Cell: (949) 289-3357
>Business email: timothy.ronak@crna.akzonobel.com
>Personal email: timronak@cox.net
>VM: (800) 234-6747 ext. 2257#




<Prev in Thread] Current Thread [Next in Thread>