wouldn't it be easier to remove the crossmember, jack-up/hang the body
and drop the engine/trans onto a sturdy crawler?
On Thu, Apr 10, 2008 at 8:18 PM, Steve Laifman <SLaifman@socal.rr.com> wrote:
> Alan, and Tigers,
>
> There are resources available to you concerning the Tiger Maintenance on
> TigersUnited.com <http://www.TigersUnited.com/>. Specifically the
> Workshop Manual describes the factory recommended procedures for most
> any task. On "Engine R&R" the applicable page is:
>
> http://www.tigersunited.com/resources/wsm/wsmB53.asp Fig. 86. shows the
> recommended hoisting procedure (provided you have a Rootes Factory hook
> height :-(
>
> There are loads of Rootes info in this document, which is available from
> Sunbeam Specialties (and thanks to Rick for his reproduction permission.)
>
> Steve
>
> ___
> Steve Laifman
> Editor - *TigersUnited.com <http://www.TigersUnited.com/>*
>
>
>
>
>
> Alan Zeni wrote:
> > I've got everything disconnected from the motor/tranny and am ready to pull
> > the pair. Unfortunately, I don't have the means to drop them out the
>bottom
> > so, according the the shop manual, I need to remove the steering rack.
>Now,
> > looking in the engine bay, it looks as though that when I drop the rear of
>the
> > tranny, the damper pully will clear the rack easily. Has anyone done this?
> > And, where are the suggested mount points for the chain?
> >
> > Thanks in advance!
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as owain.lloyd@gmail.com
>
> Tigers@autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|