Check to make sure that someone has installed the distributor wrong.
With #1 TDC the rotor should be pointing to #1 on the cap.
In a message dated 5/31/2008 1:16:36 P.M. Central Daylight Time,
tigerv8@rogers.com writes:
Hi, folks.
I finally got an opportunity to check the timing on the car today, but
not much else as we are on out way out to a friend's birthday
celebration. The manual indicates 6 degrees BTDC, with a notation that
it is acceptable to go an additional 5 degrees to deal with altitude,
and to optimize performance and fuel economy. I have also seen
elsewhere that 6-8 degrees is normal. So, I was a bit surprised to see
25 degrees! Does this seem appropriate? I tried retarding the timing
down to 10 degrees to see if that helped, but the same problem occurred
(harsh sound from the induction system under load), and the engine
really didn't seem to run as well as with the initial setting.
I hope to get some more time to work with this later or tomorrow..
Thanks,
Shaun
You are subscribed as djoh797014@aol.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
**************Get trade secrets for amazing burgers. Watch "Cooking with
Tyler Florence" on AOL Food.
(http://food.aol.com/tyler-florence?video=4&?NCID=aolfod00030000000002)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|