What is the measure of strength, perpendicular to the sheet (stacking/hanging
weights from the center as it lay flat) or parallel placing the sheet in
tension (hanging weights from the end)?
Was the non tension CF lay up physically the same after cure, smooth and flat?
Wrinkles or ridges could give a flat sheet strength. For instance the same
reason all large spans of sheet metal have creases, like car doors, hoods,
etc. All have some edge or shape to give them strength.
---------------------------------------------------------------------
Intel Electronics Ltd.
This e-mail and any attachments may contain confidential material for
the sole use of the intended recipient(s). Any review or distribution
by others is strictly prohibited. If you are not the intended
recipient, please contact the sender and delete all copies.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|