Good Morning from Sunny England,
>A while ago I bought a brake caliper from an autojumble described as
>new, old stock for a spitfire. It looked like a spitfire caliper and
>it had Type 14 written on it so I thought it OK. When I tried to fit
>it I found that the bolt centres were in the right place, so it could
>be bolted on, but it sits slightly too far into the wheel, i.e. it the
>pads are too close to the centre of the disk and the caliper touches
>the rim of the disk. In all other respects it looks like a spit
>caliper; same pads etc. However it does have "Type 14 L Mk II" on it.
>Has anyone any idea what its off?
>Many thanks,
>Jonathan Spit. 1500
Where does the brake fluid feed pipe fit? If it fits in the side of the
caliper directly behind the piston then it is most likely off a Dolomite.
Rich
|