Ken,
I usually use a small hand jig saw. I have an old one from Sears that I
got about 25 years ago. Good luck.
Jane
'67 GT6
>
>
> I am attempting to "remanufacture" four of the interior panels in the TR3
> and purchased a sheet of 1/8" masonite for the base. Every time I try to
> cut it with the reciprocating saw or the sawzall it either rips or the
edge
> "balls up" and makes a sloppy cut.
>
> Does anyone have a good suggestion to make these cuts, particularly the
> curves. I seem to get a nice cut with a circular saw and a very thin
blade,
> but this will not work on the curves.
>
> TIA
>
> kengano@advant.com
> downstate illinois
> 1959 TR3A TS57756L
> 1958 Model 10 Sedan TBE9239LDLB
|