TR6 heads

["Janssen, Lee K" <lee.k.janssen@lmco.com>]

Aaron Johnson wrote:
>On this subject I must throw in my .02.  If I were to do this again I
>would make my compression increases with the piston NOT milling the head.
>Only mill the head if you have to get it true if it is warped.  Using the
>pistons to increase the compression is the best way to go.

Okay I'll admit that I'm stupid.  I have a 74 TR6 with a 7.75:1 compression
ratio what do I buy and do?
Lee Janssen
odds and ends corner in Sunny Denver CO