triumphs
[Top] [All Lists]

RE: TR3 Wiring Harness Hold-Down Clamps

To: "'triumph list'" <triumphs@autox.team.net>
Subject: RE: TR3 Wiring Harness Hold-Down Clamps
From: "Kohout, Robert" <kohout@jbc.js.mil>
Date: Wed, 26 May 1999 10:19:22 -0400
Dave,

I have done this in the past.  Get a piece of scrap sheet metal (I have used
pieces of air conditioning duct) and cut out pieces that are the correct
length and width of the clamps you are trying to replace.  Use heat shrink,
electricians tape, or plastic dip to replicate the rubber coating.  If you
have already painted your floorboards, sand a small area to bare metal where
you want the clamp located.  Use a good quality epoxy glue and glue your
clip to the floorboard.  Allow it to dry and repaint the area.  Using this
technique after you have painted your floorboards prevents the welding heat
from damaging your paint job.  

Hope this helps.

Robert Kohout
72 TR-6

> -----Original Message-----
> From: David Moag [SMTP:moag@ix.netcom.com]
> Sent: Wednesday, May 26, 1999 12:32 AM
> To:   Triumphs Mailing List (E-mail)
> Subject:      TR3 Wiring Harness Hold-Down Clamps
> 
> 
> 
> Hello Listers,
> 
> Well I've finally started getting into the wiring of my TR3B. Actually it
> hasn't been too bad (so far), but you can expect a fair number of
> questions
> over the next week or so, especially since I'll be incorporating some
> non-original accessories. Here goes the first one.
> 
> I had new floor boards and a trunk floor put in, but they don't have those
> nice rubber coated little clamps that are welded in along the way to hold
> down the wiring harness as it travels to the rear. Since I don't do
> welding
> (although the cost of the above has convinced me I had better start before
> doing anything like this much work to another car!), does anyone have a
> suggestion for a good alternative? What kind of clamp or clip to use? What
> to attach it with? The ones in the engine bay are largely intact, so I'm
> mainly concerned with ones that are pretty much out of sight --- but I
> sure
> wouldn't mind coming up with something that looked somewhat correct while
> I'm at it.
> 
> THANKS!
> 
> Dave Moag
> 62 TR3B (a little closer each week)
> 77 Spitfire (hoping to pass it's smog test tomorrow)

<Prev in Thread] Current Thread [Next in Thread>