| To: | sujit roy <sujitroy@hotmail.com> |
|---|---|
| Subject: | Re: conversion for torque settings |
| From: | Michael Ferguson <fergie@ntplx.net> |
| Date: | Mon, 13 Sep 1999 14:44:00 -0400 |
| Cc: | triumphs@autox.team.net |
| References: | <19990913181839.18561.qmail@hotmail.com> |
Try this conversion utility... http://www.economatics.co.uk/sprint/conv05.htm No idea if it's accurate, but sure looks good. sujit roy wrote: > My newly acquired torque wrench has a reading for newton-meters > What's the conversion for kgf m to newton meters? The ROM for the Stag does > not list newton-meters > > Sujit -- Michael Ferguson 1959 TR3A TS53990L |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: extra wire in TR3A wiring harness, Jim Bauder |
|---|---|
| Next by Date: | Re: conversion for torque settings, Josh Assing |
| Previous by Thread: | conversion for torque settings, sujit roy |
| Next by Thread: | Re: conversion for torque settings, Josh Assing |
| Indexes: | [Date] [Thread] [Top] [All Lists] |