Lee,
I used a hook to get them out. I have a workshop manual that explains the
proceedure, but unfortunately it's in German, so probably of no use for you.
Very Important for all works on the metering unit is a very clean area. Be
carefull when you remove the O-rings that no dirt, dust or little metal parts
fall inside the unit, otherwise you need to disamble the whole thing and clean
it.
Contact me again if you need further help,
regards,
Jochen Saal
Munich/Germany
74 TR6
lee.k.janssen@lmco.com wrote:
>
> I would like to pull apart a lucus injector to replace the inner o-ring
> seal. The problem is I haven't seen this process documented anywhere. I
> assume you simply remove the snap ring on the injector and push all of the
> parts back up the barrel. Any experiance with this processes would be
> greatly appreciated.
> Thanks in advance
> Lee Janssen
> Denver CO
>
>
>
|