Have you disconnected the speedo and tach? The wiper knob does not screw in, as
you said, but I recall there's a hole somewhere into which you can use a sharp
object to release the knob. If you have a manual, Haynes or Bentley, the dash
removal process is addressed somewhere ...
##
OHFASTONE@aol.com wrote:
> Listers,
> I was out back pulling the dash out of my 72 GT6, two thirds of it came out
> with no problem. The left hand section is where the difficulty arose, I
> can't get it loose. Plus, on this same section is the washer/wiper switch.
> In trying to remove the knob, I noticed that it is retained by a pin pressed
> through the knob and into the shaft. Problem is, it does not appear to screw
> in and there is no hole on the opposite side to press it out. Before I do
> what crossed my mind, Iwant to hear what you have to suggest.
>
> Michael
|