Re: Bolts holding TR3 Rad !!!!

[Rosspemlee@aol.com]

You are probably not going to like it but I drilled two holes under the bolt 
beads just large enough to accept the socket. works great and doesn't weaken 
crossmember that much. Especially handy if you are going to remove rad. on a 
regular basis (race car)
This is an old Tr mech trick. You can also set up a bolt w/a nut on top of 
the bracket but under the rad, install the rad and then put another nut on 
top of it and only remove the second nut when you remove the rad in the 
future.