Message text written by "Wages, Jeffrey"
>It appears my '71 TR6 has developed a leak in the brake warning valve
sensor. My question is, what is the best practice for fixing this
engineering marvel? I thought I had seen some recommendations other than
replacing the seal.
<
If it is leaking out of the switch (nost likely) then one or the other (or
both) O-rings are leaking. Replacing these is fairly straight forward.
Remove the big plug at the one end, shake out the shuttle, replace the
O-rings and re-assemble.
Best done out of the car.
Get O-rings that will tolerate brake fluid.
Cheers
Dave
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|