A square piece of 4x4 and a hammer. Be sure to remove the figure 8
gasket and replace after cleaning the ledge on which it sits.
Reinstalling can be done with a longer piece of 2x4 and a hammer,
although the liners will be proud until you torque the head down.
Bill
MRobe33243@aol.com wrote:
>Hello Triumphland:
>
> I am looking for someone with first hand knowledge of the removal and
>installation of TR4 cylinder liners. I have three manuals and all seem to
>shun
>the subject to some degree, especially the removal phase.
>
> Any guidance would be deeply appreciated.
>
>Bob Roberts
>TR$$$$
>35411CT
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|