triumphs
[Top] [All Lists]

Re: TR3A cooling again

To: "Randall" <tr3driver@comcast.net>
Subject: Re: TR3A cooling again
From: TeriAnn Wakeman <twakeman@cruzers.com> i83DfrdM030875
Date: Fri, 3 Sep 2004 06:41:46 -0700
Cc: "TR List" <triumphs@autox.team.net>
>> Do you have a factory grille or a reproduction?
>
> That is an excellent point, and one I had forgotten about.  What Teri 
> is
> referring to is that the reproduction TR3A grilles have smaller 
> openings
> than the factory ones did.

I just uploaded a jpeg

www.cruzers.com/~twakeman/TR/TR3Agrills.jpg

The top grille is the reproduction, the lower one is the factory 
original.

They seem to use the same amount of metal in the replacement grill but 
do not fold the 'V's as deeply. Result less area for air to flow 
through and more edge interference with the flow.  The after market 
grill has holes 7.2 cm(2.83 inches) by 1.3 cm(.51 inches) for a 9.36 
cm^2(1.44 square inch) opening.  The factory grill has holes 7.7 
cm(3.03 inches) by 1.6 cm(0.63 inches) for a 12.32 cm^2(1.91 square 
inch) opening, providing 24% more area for air to flow to the radiator.

I spent part of a VTR meet measuring a bunch of TR3A grilles to verify 
the measurements were uniform.  My 3A runs cooler since I switched 
back.  Of course replacing the broken generator mounting bracket that 
allowed the front of the generator to move inward when the engine was 
running, causing the fan belt to loosen helped too.

I have a web page on how skirted thermostats work that may help:

www.cruzers.com/~twakeman/TR/thermostat.htm



T. J. Wakeman

1960 Land Rover 109 Dormobile owned since 1978
1961 Triumph TR3A  owned since 1986, the new car

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8




<Prev in Thread] Current Thread [Next in Thread>