Well I decided to have a go and seem to have hit a snag.
The back of the spring pan hits the chassis which is stopping the spring and
damper from dropping.
I undid the bump stop and jacked the pan up and undid the bolts holding the
plate under the damper then undid the 6 pan bolts.
I have put in the two guide bolts and dropped the jack but the spring and
damper won't drop. Do I jack it up again and lever the pan out. Should the
damper have come out separate to the spring?
Jim and his even blacker 1962 TR4
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|