My wife is having difficulty in shifting her TR3 into first gear at a stop. I
have worked with her on letting the clutch out slightly etc, but it's like it
just will not slide into gear for her. I don't have as much trouble, but it is
difficult at times. It is a non-syncro overdrive. Before installing it I put
in bearings, seals and syncro's, but did nothing to the top cover or shifter
slides. From the wisdom of the list, Is the top cover the best place to start?
Clean shafts, new seals, and shift shaft lubrication? What is the recommended
lubricant that will stay without attracting too much dirt? Any help is ALWAYS
appreciated
THANKS
Kent Shrack TS78563 o
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|