triumphs
[Top] [All Lists]

Re: [TR] 1)Engine Block Interior, Liner Paint &2)Venting

To: "Triumphs" <triumphs@autox.team.net>
Subject: Re: [TR] 1)Engine Block Interior, Liner Paint &2)Venting
From: "Karl Vacek" <kvacek@ameritech.net>
Date: Fri, 21 Nov 2008 22:53:48 -0600
I don't know why GE developed Glyptal, but I remember seeing it in the 
Allied Radio catalog in the late 1950's for use as a paint-on insulation for 
electrical connections and components.  I think it was intended for similar 
uses as the stuff you can buy at hardware stores today.  But Glyptal was 
certainly a high-perforamnce product as opposed to the consumer stuff you 
can buy in the electrical department at Home Depot, etc. today.  Back then 
it was really expen$ive too - for a little bottle.  Must be less expensive 
today if people regularly coat entire insides of engines "just because".

I thought that racers had discovered its usefulness for race engines maybe 
30 years ago, for smoothing out the inside of blocks to allow oil to flow 
back to the pan (and thus the pump) faster.

But I dunno, really...

Karl



> The story on
> Gyptal as I was told is that it was originally developed by GE to be used
> seal the insides of castings that would hold oil. The idea is that it will
> tend to keep the crankcase cleaner, longer because the oil will tend to 
> run
> down the sides of the slick surface and not congeal into the crud we have
> all cleaned off the inside of engines one time or another.
> It must have been around for quite awhile as I remember my dad using it 
> when
> rebuilding antique cars when I was young.
>
> Dave Connitt
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>