triumphs
[Top] [All Lists]

Re: [TR] Overheatng

To: terryrs@comcast.net
Subject: Re: [TR] Overheatng
From: Geo Hahn <ahwahneetr@gmail.com>
Date: Fri, 24 Aug 2012 15:25:09 -0700
Cc: Triumphs <triumphs@autox.team.net>
Delivered-to: triumphs-archive@autox.team.net
Delivered-to: triumphs@autox.team.net
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=20120113; h=mime-version:in-reply-to:references:date:message-id:subject:from:to :cc:content-type; bh=c9JLsjMf1+jP0GRxuzAiP1qwnwLW4wBg8XWRE9vHCiI=; b=BbIlwFE9DCN2WdzFTe72dJ39RjokRiKMC8lx9mLzqzx/XbndWYV652CIxOrYCtWHpR Ykht9rKY2KaO4PXARRvuRNJcMh/tezjZxe3Asu4QAxqnczuJCBnuVyvwADl8H11uwH1Y eMqxNyVAtCcIKiFQ/owj9YKu2aKyU8XKqfnZd6/v+GjdPxNEkBdD8wG3Xs3ecYQ4MF+C HFo0/u8G6feLUH4h5cBndUJnPM7si8QzmL9y7S0+bEf7Z7GfkNd+HGZ1fjZYDntx9ifw vZtZWzTSUgl1atqgsH/d1cyWFGd45FEDYZl4gwPHnrn6lKaPR+3feSAEDJPZKJv03glL hYKA==
In-reply-to: <342001455.938795.1345844485628.JavaMail.root@sz0059a.westchester.pa.mail.comcast.net>
List-archive: <http://autox.team.net/pipermail/triumphs>
List-help: <mailto:triumphs-request@autox.team.net?subject=help>
List-id: Triumph Sports car discussion <triumphs.autox.team.net>
List-post: <mailto:triumphs@autox.team.net>
List-subscribe: <http://autox.team.net/mailman/listinfo/triumphs>, <mailto:triumphs-request@autox.team.net?subject=subscribe>
List-unsubscribe: <http://autox.team.net/mailman/options/triumphs>, <mailto:triumphs-request@autox.team.net?subject=unsubscribe>
References: <CANLCLaEbsatrfjiWp6yMoCDPVw9m4KNDJGSK46FkjaoAhBbSnA@mail.gmail.com> <342001455.938795.1345844485628.JavaMail.root@sz0059a.westchester.pa.mail.comcast.net>
Sender: triumphs-bounces@autox.team.net
One simple test is to remove the belt altogether and briefly run the engine
-- if the noise is gone that would narrow the search down to water pump,
alternator or belt.

A suspect belt can sometimes be diagnosed by spraying a bit of WD40 on it
while the engine is running.  If that immediately elminates the squeal then
it is the belt.  The WD40 is not a fix, just for diagnosis.

I have quieted a noisy belt by (very carefully) hold a sanding block
against the sides of the Vee as the engine runs.  This scuffs the belt a
bit and breaks up the glaze if that is what is cauing the noise.

Geo

On Fri, Aug 24, 2012 at 2:41 PM, <terryrs@comcast.net> wrote:

> History.  Have about three thousand miles on the engine rebuild.  When I
> started it the first time, there was intense squealing for a few seconds
> that then went way.  I figured it for a dry water pump.
>
> Squealing has returned.  Sounds for all the world like a fan belt issue or
> a bad bearing on either the water pump or alternator.  Tried the
> stethoscope, couldn't isolate, so swapped out the water pump.  Squeal
> persisted.  Stethoscoped the alternator again, couldn't isolate, but then
> accidently dropped cold water on the alternator and the sound stopped
> abruptly.  What was THAT all about??
>
> So, bought a new GM alternator, adapted it to fit, put the old wide-belt
> pulley on it, and reinstalled.  Same squeal as before.
>
> But in the past week, the engine is overheating at idle and in hot
> weather. I'm running the belt looser than I usually do, but watching the
> action, the pulleys all seem to be turning, but am wondering if they're not
> going as fast as they should and the squealing is slippage?
>
> Will try belt dressing to see if that changes anything.
>
> Question:  If I was spinning a crank bearing, either main or rod, it would
> make much different noises than a belt squeal, right?
>
> Terry Smith, '59 TR3A
> New Hampshire
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/ahwahneetr@gmail.com

** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/triumphs-archive@autox.team.net

<Prev in Thread] Current Thread [Next in Thread>