Re: [TR] GT6+ emissions distributor

[ptegler <ptegler@verizon.net>]

if you pop off the points plate, then pull the little screw in the top 
center you can lift off the top hald of the mech adv weights plate. The 
adv degrees number will be stamped right into the plate.
remember though that number is on half of the crank adv value   so if 
stamped 6 degrees it's 12 at the crank  10 would be 20 at the crank etc.

as general info.... mech adv is usually 20 or less (usually less) a the 
crank
ptegler


On 10/2/2014 5:06 PM, David Porter wrote:
> Anyone know what the total allowable ignition advance is for these 
> Delco-Remy units?
>  I'm only seeing about 15 degrees at 3000 + RPM   Doesn't seem enough 
> to me..
> Dave

** triumphs@autox.team.net **

Archive: http://www.team.net/archive