triumphs
[Top] [All Lists]

Re: [TR] Workbench rebuild

To: triumphs@autox.team.net
Subject: Re: [TR] Workbench rebuild
From: Chris Kantarjiev <cak@dimebank.com>
Date: Sun, 20 Mar 2016 14:00:57 -0700
Delivered-to: mharc@autox.team.net
Delivered-to: triumphs@autox.team.net
References: <mailman.11.1458496803.4515.triumphs@autox.team.net>
User-agent: Mozilla/5.0 (Macintosh; Intel Mac OS X 10.10; rv:38.0) Gecko/20100101 Thunderbird/38.6.0
I'd say "it depends" - on what you intend to use this workbench for.

For a general purpose bench, my favorite design so far is based on a 2x4 
or 2x6 frame, with plywood or butcher block over the top (depending on 
price and availability: 5/8", 2 sheets of 1/2", 1") topped with MDF 
("Masonite"). The plywood is screwed to the frame and the MDF is glued 
down. For bonus points, trim the edges with MDF, too. Let the top 
overhang by an inch or two for clamping.

MDF is a very forgiving surface: it absorbs oil and moisture, it won't 
damage parts when you drop them, it doesn't gouge very badly. And you 
can sand it down once or twice and then pry it off and replace it.

I have used galvanized steel (from an HVAC fitter) for counter tops. It 
has its place, but it can be hard on tools and parts that interact with it.

Plate steel can't be beat for a welding bench, but I wouldn't want to do 
generalized work on it.

I usually attach the bench to the garage framing studs with lag bolts, 
ideally in a corner. That makes it super stable - use a 4x4 or larger on 
the "free" end and mount your vise there.

** triumphs@autox.team.net **

Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>