triumphs
[Top] [All Lists]

[Fot] Wilwood 570 brake fluid

Subject: [Fot] Wilwood 570 brake fluid
From: toodamnfunky at comcast.net (JAMES GRAY)
Date: Mon, 26 Feb 2018 10:35:37 -0700 (MST)
References: <CAO0FjVZmJ0Rx1zR4Uxo=YgYSbQoEB8T2H9kHkZ68i0sQG2G61g@mail.gmail.com>
The only Triumph brake components I have left are the rear slave cylinders and 
they are fine with Motul 600.

I used it with the stock clutch master & slave too with no problems. That's all 
gone now in favor of a fully hydraulic

clutch.

jim g

> On February 26, 2018 at 6:49 AM Mike Harmuth via Fot <fot at autox.team.net> 
> wrote:
> 
>     I just replaced my brake master cylinder (Girling) and the braided lines 
> attached to it. I've been using Valvoline DOT 3/4 fluid and it's worked out 
> OK but at one track (Thompson), I'm always over heating the fluid. I used to 
> use Wilwood 570 in my F440 car and thought I'd give it a try in the Spitfire 
> since it has a higher boiling point than the Valvoline.
> 
>     My concern, probably from leaking seals in the past, was the difference 
> between US Spec DOT 3 (Wilwood) and English DOT 3 fluids. The DOT 4 seems to 
> be compatible, but at with lower boiling temperature than the specialty fluid.
> 
>     Has any one used the Wilwood with Triumph OEM grade brake parts?
> 
>     thanks
>     mike
>     _______________________________________________
>     fot at autox.team.net
> 
>     http://www.fot-racing.com
> 
>     Donate: http://www.team.net/donate.html
>     Archive: http://www.team.net/archive
>     Forums: http://www.team.net/forums
>     Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/fot/toodamnfunky at comcast.net
> 
> 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/fot/attachments/20180226/0d7d8822/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>