--===============7419272257073048236==
--00000000000088b3a605bf64a4cf
I need a bolt HB815 which is at 5/16 x 1 7/8" long.
Rimmer and TRF list this no. under a 2 inch bolt. I'm assuming you can't
get 1 /78" long bolt anymore. I tried fastenal and Bolt Depot. Not tried
mcMaster carr.
The last time I needed one of these I bought a 2" bolt and cut a bit of the
end.
I'm just wondering when a blind hole is drilled for a bolt, how much dead
space is left at the end? Is there some rule of thumb?
Sujit
--
Sujit Roy
Cupertino, California
https://triumphstagblog.wordpress.com/
--00000000000088b3a605bf64a4cf
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">I need a bolt HB815 which is at 5/16 x 1 7/8" long.=
=C2=A0<div>Rimmer and TRF list this no. under a 2 inch bolt. I'm assumi=
ng=C2=A0you can't get 1 /78" long bolt anymore. I tried fastenal a=
nd Bolt Depot. Not tried mcMaster carr.=C2=A0</div><div>The last time I nee=
ded one of these I bought a 2" bolt and cut a bit of the end.</div><di=
v>I'm just=C2=A0wondering when a blind hole is drilled=C2=A0for a bolt,=
how much dead space is left at the end? Is there some rule of thumb?</div>=
<div><br></div><div>Sujit<br clear=3D"all"><div><br></div>-- <br><div dir=
=3D"ltr" class=3D"gmail_signature" data-smartmail=3D"gmail_signature"><div =
dir=3D"ltr"><div>Sujit Roy<br>Cupertino, California</div><div><br><a href=
=3D"https://triumphstagblog.wordpress.com/"; target=3D"_blank">https://trium=
phstagblog.wordpress.com/</a><br><br></div></div></div></div></div>
--00000000000088b3a605bf64a4cf--
--===============7419272257073048236==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
** triumphs@autox.team.net **
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
--===============7419272257073048236==--
|