I've made shims with beer cans before, but it's probably not as good
as a proper yoke replacement. I can't remember if it lasted very long
or not.
On Mon, Sep 6, 2021 at 5:14 PM Cliff Hansen <cliff_hansen@outlook.com> wrote:
>
> Hi list,
>
>
>
> Iâ??m replacing u-joints in the rear axles (TR4A). On one end I can slip two
> of the caps in by hand (one on the flange, one on the yoke).
>
>
>
> Anyone here think I could get by here with some Loctite or similar to hold
> the cap in place? Or am I looking for a replacement axle?
>
>
>
> This is not a track car, but I prioritize reliability.
>
>
>
> Thanks,
>
>
>
> Cliff
>
>
>
>
>
> Sent from Mail for Windows
>
>
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/fishplate@gmail.com
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|