[6pack] Help with Sync'ing those darn carbs...II

[Jay Snable]

I never had much luck with the unisyn myself, and ended up getting a synchrometer from Richard Good that works much better (of course it is much more expensive too):

http://www.goodparts.com/shop/index.php?categoryID=7

Jay
 
On Wednesday, November 19, 2008, at 11:22AM, "James_ TR6" <jattr6 at hotmail.com> wrote:
>So I forgot to mention, I did have the linkage loosened so each carb would
>move independently. so my method has been to adjust the idle screw and tweak
>the jet needle. then i place the unisync over one carb, adjust the wheel so
>the float
>is in the middle-ish and then place over the other carb. but it either makes
>the other
>carb stall out or race. the ball of course is way off and does not much the
>other carb.
>
>well, i probably just need to fiddle around. just wish there was a formula!
>LOL!
>and maybe to a degree there is...either the idle screw or needle.