[6pack] Floorpan replacement and Rust repair quote...

[James_]

Thanks everyone for the great words and advice.
I want a good job and get her on the road so i can drive it. but with all these rusted out sections, i need to repair them first.
I am totally tempted to go out, buy a TIG welder (a bit expensive) and LEARN to weld!Seriously. I haven't seen any welding classes over the summer, but there will be many in the Fall. But I can teach myself and find friends of friendsinstruct me.I would not do the floor pans but at least the flat sections needing repair. One area is on the firewall near the commission plates . probably a 1"x5" section.
So most sections I need are flat sections. Except for the crazy corner section directly under the fuse box, master cylinder area.Which leads me to this: If I can locate a perfect salvaged inner fender and wheel arch that I can extract this crazy multi-sidedsection. I simply cut out the bad and have someone weld in the good replacement. saves fabricating from scratch. or do it myself. 
Anyone have a good source to find donor panels: wheel arch/inner fender sections?Ideally here in Oregon, but willing to pay for shipping. Be even nicer if someone has the small section I need and not have to ruin a good part that is intact.
Thanks.
James
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/6pack/attachments/20150610/94386828/attachment.html>