[Roadsters] looking for a distributor testing machine

Bubba bubwin at mts.net
Mon Apr 14 08:45:10 MDT 2008


The old engine analyzers did use oscilloscope, but there were actual 
machines to test distributors.  Years ago I actually had one until it died, 
and I couldn't beg, borrow, steal, make or customize any of the parts 
needed.  I kept it for several years until I needed the bench space.

Distributor testers were a form of machine that you clamped the distributor 
in and you could spin the distributor shaft, and adjust the speed from an 
idle speed to several thousand RPM.  There were meters mounted on it that 
read the RPM and dwell angle (the # of degrees of rotation that the points 
were closed).

It also had a vacuum pump to connect to the vacuum advance, and a strobe 
light which showed where in the rotation the points opened (distributor 
timing).  You could actually set the points while it turned, as you ran it 
without cap or rotor by observing the dwell reading.  Dwell reading is more 
accurate than point gap.

By running the distributor on the machine you could measure the amount of 
vacuum advance, mechanical advance (centrifugal), or total advance (vacuum 
and mechanical).  If you were testing different counter-weights and springs 
on a mechanical advance, you could do so quickly, easily, and without 
bending over a fender and trying to read your timing marks.  On vehicles 
with adjustable vacuum advance, adjustments were quick as well.

You could set up a basic distributor in minutes.  Sometimes you could use a 
strobe light, and even watch for movement in the distributor shaft through 
various RPM ranges, which was great to diagnose worn bushings.

AAAAHHHHHH the good old days, when cars were cars, men for men, and onboard 
computers were science fiction.

Bob Winslade
1966-1600 Missy
1967-1600 Bender


----- Original Message ----- 
From: <davesmbox at aol.com>
To: <sumton at sbcglobal.net>
Cc: <datsun-roadsters at autox.team.net>
Sent: Monday, April 14, 2008 7:02 AM
Subject: Re: [Roadsters] looking for a distributor testing machine


> Wasn't that done with an osciliscope?
>
>
>
>
>
>
>
>
> -----Original Message-----
> From: oliver <sumton at sbcglobal.net>
> To: datsun-roadsters at autox.team.net
> Sent: Sun, 13 Apr 2008 11:41 pm
> Subject: [Roadsters] looking for a distributor testing machine
>
>
>
> i know.  every shop used to have one, now no one does.
>
>  we are looking for a machine to test/calibrate dizzy's.
>
>  been looking around with no success.  any leads/suggestions?
> You are subscribed as davesmbox at aol.com
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters
> ________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as bubwin at mts.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters


More information about the Datsun-roadsters mailing list