[Roadsters] License plate lamp

[Gary and Cindy Ault]

John,

The wire with the bullet connects to the wire coming from the lamp.  The 
other wire is a ground wire, which should be black, and should have a 
half-round terminal on the end.  Connect it to one of the mounting studs for 
the lamp.

Having said that, depending o your cars ownership history and its condition 
otherwise (How accurately the the POs maintain the car -- any evidence of 
gross stupidity?) you might want to check the lead with the bullet for 
polarity -- should be ~12 volts positive -- before making the connections 
and assuming the wiring is correct.  (SInce there is a bullet connector on 
one wire, I think it is highly unlikely there will be a problem.)

Gary Ault
'66 1600/U20 (since 1971)
'67-1/2 2000 (new toy)

----- Original Message ----- 
From: "JohnnyRoadster" <JohnnyRoadster at comcast.net>
To: <datsun-roadsters at autox.team.net>
Sent: Thursday, October 30, 2008 1:20 PM
Subject: [Roadsters] License plate lamp


>I was installing the rear bumper last night.  It looks like there were two
> wires coming off the harness where the lamp is.  One is obvious, since it 
> has
> the bullet type plug connector.  But the other one I am guessing is a 
> ground
> that I put under the screw (on the bumper) for the license plate lamp. 
> Can
> anyone verify that this is correct?
>
> John
>
> SPL311-19356
> http://community.webshots.com/user/johnnyroadster
> ________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as aultgc at att.net
>
> Datsun-roadsters mailing list
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/datsun-roadsters