[Fot] crank scrapers available

[Charly Mitchel]

Hey Jack are you think of making scrapers for the TR6 motor?  I know of at 
least 2 sales immediately, maybe 3.
Charly Mitchel
TR6 #44
----- Original Message ----- 
From: "Jack W. Drews" <vinttr4 at geneseo.net>
To: <fot at autox.team.net>
Sent: Saturday, November 17, 2007 5:58 PM
Subject: [Fot] crank scrapers available


> Some time ago I designed a crank scraper for the TR3 - 4 engine. I
> designed two, actually - one for the stock crank / stock rod engine,
> and one for the Moldex / Carillo engine. Several of us are using
> them. Since designing these things and programming for laser cutting
> is very time consuming, I have not made them for the Spitfire or TR6 
> engine.
>
> They are made from 1/8" steel and mount under the heads of three main
> cap bolts. They come with three hardened washers to go between the
> bolt heads and the scraper.
>
> You can see a picture on Tony's site -- www.Tonydrews.com -- link
> "Jack's Parts"
>
> There was not much interest at the time so I had a limited run made
> of each configuration. I still have a few of them left.
> I'll sell the ones I still have for $64.95 apiece plus shipping.
>
> uncle jack
>
>
>
> ------------------------------------------------
> No Virus Found In This Message
> Scanned at barracuda.geneseo.net
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot at autox.team.net
> http://autox.team.net/mailman/listinfo/fot