[Fot] TR3 Torque plate

[Catpusher at aol.com]

Some of you may recall that I use a MF Tractor head (sent in error to the 
Brisbane BL depot) with 4 holes cut in it for the hone to pass through.  The idea 
was to more accuratly clamp the liners in than with a simple plate.  I also 
installed the BFE liners fully before honing, and did not remove them after 
that.  A full National season (or more)  later they were still true.
 
The other option is to not run (a) good air filter(s), and "re-hone" them as 
you race......
 
Hardy
 
In a message dated 11/9/2008 11:07:58 AM Pacific Standard Time, 
fot-request at autox.team.net writes:

From: N197TR4 at cs.com
Subject: Re: [Fot] 87mm liner needed
To: Billb at bnj.com (Bill Babcock)
Cc: fot at autox.team.net
Message-ID: <1FED7D63.45473248.00159EE9 at cs.com>
Content-Type: text/plain; charset=iso-8859-1

I wonder if the shape changes to something different everytime the torque 
plate or head is applied.

perhaps the variations may 'stack up' against you.

perhaps the 'perfect' part minimizes this chance.

only conjecture on part. no data.

joe 


**************AOL Search: Your one stop for directions, recipes and all other 
Holiday needs. Search Now. 
(http://pr.atwola.com/promoclk/100000075x1212792382x1200798498/aol?redir=http://searchblog.aol.com/2008/11/04/happy-holidays-from
-aol-search/?ncid=emlcntussear00000001)