[Fot] TR3 Torque plate
N197TR4 at cs.com
N197TR4 at cs.com
Mon Nov 10 20:55:52 MST 2008
Seems brilliant to me....
of course, few people know you employ an in-house engineering staff of one. You know, the one with prominent whiskers. Wise well beyond his nine lives.
Joe A
>
>Some of you may recall that I use a MF Tractor head (sent in error to the
>Brisbane BL depot) with 4 holes cut in it for the hone to pass through. The idea
>was to more accuratly clamp the liners in than with a simple plate. I also
>installed the BFE liners fully before honing, and did not remove them after
>that. A full National season (or more) later they were still true.
>
>The other option is to not run (a) good air filter(s), and "re-hone" them as
>you race......
>
>Hardy
>
>In a message dated 11/9/2008 11:07:58 AM Pacific Standard Time,
>fot-request at autox.team.net writes:
More information about the Fot
mailing list