[Fot] TR6 transmission rebuild - counter shaft gears

[fubog1]

It probably has the later type shell bearings and 1 or both have worked loose in the laygear housing bore and "milled" into the thrust washer (s).
Glen

 

 

 

-----Original Message-----
From: Greg Blake via Fot <fot at autox.team.net>
To: Fot <fot at autox.team.net>
Sent: Sun, Jan 7, 2018 8:56 pm
Subject: [Fot] TR6 transmission rebuild - counter shaft gears

I am rebuilding a TR6 transmission and ran into a strange snag. When I removed the countershaft the counter shaft gears did not drop to the bottom of the case. I had to tap on the counter shaft gear set with a brass punch to get them to move far enough to allow the input shaft and gear to be removed. Now that I have the main shaft out of the case, I can't get the counter shaft gears out of the case. I've been able to move them a little bit by tapping on the gears with a brass punch through the drain hole but I can't get them out. Has anyone run into this before?  Any ideas to get them out?

Thanks. 

Greg

Sent from my iPhone
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/fubog1@aol.com



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20180108/6b9e8881/attachment-0001.htm>