[Fot] (no subject)

[Bill Tobin]

Hi All, I use the same setup as Phil, with good results.

Squaring the pads is in one of Kas' books. Its making the pad surface 
flat. He said to use a drill press to do it.

I'm spoiled, I use a surface grinder with a magnetic chuck; chuck the 
pad in place, run the grinding wheel down until it touches , and run the 
pad back and forth under the wheel until flat and square.

Nice to have equipment! Anyone need an engine lathe? I just saved one 
from the scrapper. I'll clean it up and sell it. I hate to see equipment 
like that scrapped.

Cheers, Bill

On 7/20/2019 7:38 PM, Mathieu W. Huovinen via Fot wrote:
>
> Squaring up the pads? Please tell me more, I'm still learning. Thanks!
>
> -Marhieu
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/william.tobin31@verizon.net
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20190720/d7ea486f/attachment-0001.htm>