[Fot] (no subject)

[marty]

Huh, finally found something I can use my surface grinder for. 🙂 Probably don't want to breath that stuff though.

Marty

________________________________
From: Fot <fot-bounces at autox.team.net> on behalf of Bill Tobin via Fot <fot at autox.team.net>
Sent: Saturday, July 20, 2019 10:35 PM
To: fot at autox.team.net <fot at autox.team.net>
Subject: Re: [Fot] (no subject)


Hi All, I use the same setup as Phil, with good results.

Squaring the pads is in one of Kas' books. Its making the pad surface flat. He said to use a drill press to do it.

I'm spoiled, I use a surface grinder with a magnetic chuck; chuck the pad in place, run the grinding wheel down until it touches , and run the pad back and forth under the wheel until flat and square.

Nice to have equipment! Anyone need an engine lathe? I just saved one from the scrapper. I'll clean it up and sell it. I hate to see equipment like that scrapped.

Cheers, Bill

On 7/20/2019 7:38 PM, Mathieu W. Huovinen via Fot wrote:

Squaring up the pads? Please tell me more, I'm still learning. Thanks!

-Marhieu



_______________________________________________
fot at autox.team.net<mailto:fot at autox.team.net>

http://www.fot-racing.com

Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/william.tobin31@verizon.net



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/fot/attachments/20190721/7c127d0c/attachment-0001.htm>