[Healeys] Advice and guidance needed for OD reinstallation

[Al Fuller]

Len, as regards your request for advice on remounting the overdrive - I
would echo the advice from two prior posters: remove the gearbox, secure it
on the bench input shaft down and install the OD there.

You'll thank them later...

________________
Sent from my phone
Best Regards,
Al Fuller

On Wed, Aug 27, 2025, 1:23 PM Leonard Berkowitz via Healeys <
healeys at autox.team.net> wrote:

> Hi. All
> I finally figured out how to get the OD out of my BJ7. Now for getting the
> new one installed. I found two rings sitting on the output shaft which I
> believe are fitted to the adapter plate. (See pics attached). The problem
> is going to be how to keep them in place while maneuvering the new OD into
> place. I was thinking of using either white lithium grease or wheel bearing
> grease.
> Any suggestions?
> Thank you in advance for any help you can offer.
>
> Len Berkowitz
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/alfuller194@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20250827/dce8270e/attachment.htm>