[Healeys] 3000 turn signal control box access

[john spaur]

I can remove the control box on my BT7 without cutting the duct so you should be able to do so on your BJ8. However, it is difficult to do. As mentioned by Rick, the points should be cleaned. The contact distance between the points should be checked and adjusted.

John
1962 BT7

________________________________
From: Healeys <healeys-bounces at autox.team.net> on behalf of Ken Freese via Healeys <healeys at autox.team.net>
Sent: Wednesday, December 3, 2025 10:09:14 PM
To: AustinHealeylist <healeys at autox.team.net>
Subject: [Healeys] 3000 turn signal control box access

I have traced the fault of my left front turn signal to the big control
box on the left inner fender. The upper mounting screw of the box is
under the fresh air duct. I think I have to cut the duct as I can't
shove it back towards the carbs more than a couple of inches. I thought
of piecing the duct back together with some large pvc sleeve inside it.
What does the list think?
Also are the repro relay boxes any good?
Thanks,
Ken Freese
65 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive/healeys

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20251204/3a669fa7/attachment.htm>