[Healeys] Radius arm replacement BJ8

[dwernervt at gmail.com]

I’m in the midst of replacing the rear wheel bearings, seals, etc. The backing plates are now blasted and the paint is curing. Shocks, links, hand brake cable and fittings were done last year, but it didn’t have time to get to the radius arms.
Anyone have a tried and true procedure to get these out? Disconnect the prop shaft, brake line tee fitting, handbrake fittings and then support the axle housing and lower the springs enough to rotate the housing rearward?
Thanks,
Dan Werner

Sent from my iPad