[Healeys] Radius arm replacement BJ8

[Michael Salter]

Further to my earlier comment, perhaps you should examine your motives for
replacing the radius arm bushes. Is it necessary?
The original bushes are very robust and were made by Metalastic which I
believe was a division of Dunlop. Unless they are abused in some way they
seem to last forever.

M

On Sun., Mar. 16, 2025, 3:01 p.m. , <dwernervt at gmail.com> wrote:

> I’m in the midst of replacing the rear wheel bearings, seals, etc. The
> backing plates are now blasted and the paint is curing. Shocks, links, hand
> brake cable and fittings were done last year, but it didn’t have time to
> get to the radius arms.
> Anyone have a tried and true procedure to get these out? Disconnect the
> prop shaft, brake line tee fitting, handbrake fittings and then support the
> axle housing and lower the springs enough to rotate the housing rearward?
> Thanks,
> Dan Werner
>
> Sent from my iPad
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/healeys/attachments/20250317/a271503e/attachment.htm>