[JAGNUTS] Need a Distributor Part
Bob
jaguar at englandengineering.com
Sun May 27 20:27:17 MDT 2012
Tony
That would be great! Either one is fine.
Bob
-----Original Message-----
From: jagnuts-bounces at autox.team.net [mailto:jagnuts-bounces at autox.team.net]
On Behalf Of Anthony Koschinsky
Sent: May 27, 2012 5:34 PM
To: JAGNUTS Regina
Subject: Re: [JAGNUTS] Need a Distributor Part
I can bring one to the office tomorrow. Do you prefer Phillips or slotted?
Sent from my iPhone
On 2012-05-27, at 4:48 PM, "Bob" <jaguar at englandengineering.com> wrote:
> I'm hoping someone out there might have the small machine screw that
> holds the condenser in the distributor. I went to change the
> condenser in the E today and found that the Phillips notches in the
> head of the screw are completely stripped. It was no problem getting
> the screw out with a set of small pliers and I could reuse it in a
> pinch, but if someone has a spare of these machine screws out there
> that would be much better. Alternatively,
if
> someone knows somewhere in town that you can get one (it is not metric
> nor standard imperial - I suspect it is one of those BA type machine
screws).
> The distributor is a Lucas.
>
>
>
> Thanks.
>
>
>
> Bob
> _______________________________________________
> JAGNUTS Regina - mailing list
> REPLY TO : Jagnuts at autox.team.net
> http://nonprofits.accesscomm.ca/jagnuts/Jagnuts.htm
> _______________________________________________
_______________________________________________
JAGNUTS Regina - mailing list
REPLY TO : Jagnuts at autox.team.net
http://nonprofits.accesscomm.ca/jagnuts/Jagnuts.htm
_______________________________________________
More information about the Jagnuts
mailing list