[Mg-mmm] 3 brush dynamo
TATERRY at aol.com
TATERRY at aol.com
Sun Jan 16 14:04:49 MST 2011
Nick Feakes, who runs the MGCC MMM Register web site recently put the
following on that site. I thought it might be useful to folks here. Nick is
writing a book on MMM electrics and it should be available soon.
Posted - 14/01/2011 : 12:41:55
(http://www.triple-mregister.org/forums/pop_profile.asp?mode=display&id=5)
(javascript:openWindow('pop_mail.asp?id=5'))
(http://www.triple-mregister.org/forums/post.asp?method=ReplyQuote&REPLY_ID=15540&TOPIC_ID=3936&FORUM_ID=7)
____________________________________
I am still working on the book but part of the chapter that covers this
issue may appear in the Year book.
To convert from three brush to two brush is quite simple (and much easier
with the dynamo out of the car).
1. Remove the third brush completely.
2. Transfer the field wire that was connected to the third brush screw
terminal and connect it to the grounded main brush (this is the one without a
wire connected to the screw terminal).
You will now need some sort of voltage regulator.
Terry
More information about the Mg-mmm
mailing list