[Shotimes] MTX wires in place of ATX

[Steve Weinrich]

The MTX wires work fine, I installed them an a buddy's ATX a couple months
ago.  I had the intake off anyway which made it very easy.  The wires for
the rear are shorter than the ATX wires, but they will reach with some
creativity.

One thing to watch out for when putting it back together - when I
reinstalled the manifold, I got the wires under one of the small hoses that
are under the TB.  The pressure of the wires pushing against the hose caused
the hose to split within a week or two, dumping orange coolant everywhere.

If you leave the intake on, you don't need to worry about this potential
problem.

Steve


----- Original Message -----
From: <KICKINSHO@aol.com>
To: <shotimes@autox.team.net>
Sent: Monday, December 09, 2002 10:27 PM
Subject: [Shotimes] MTX wires in place of ATX


> Hi All,
>
> Thought I would try this again.  I have looked in a few different areas
with
> no luck.  Hopefully I haven't overlooked the information I am searching
for.
>
>
> Does anyone out there know how the MTX wires should be routed to fit on an
> ATX ? Is there even a different route?
>
> Yes, I am trying to save some money.  I have spent way too much in the
last
> few months on my cars and need to watch my money however I can.
>
> Any  information is hugely appreciated!!!!!!
>
> TIA,
>
> Kris
> '91+ White
> '93 Ultra Red ATX
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes