[Shotimes] Strange noise...help!

[Paul L Fisher]

Without the noise, I would suggest it is the oil pressure sensor. I would
change that 1st anyhow. 67K miles is low for a rod knock. Mine didn't start
until 165K or so and only under certain situations.

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 167K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus
Stainless Steel Y-pipe, Delrin sub-frame bushings, Amsoil Series 2000 0W-30
oil, Amsoil Synthetic ATF.
'00 Ford Explorer XLT 5.0L V8 AWD Oxford White Clearcoat 34K Build date
11/19/1999
- Amsoil Series 2000 0W-30 oil, K&N Fuel Injection Performance Kit

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm

Get $5 free from Paypal! https://www.paypal.com/refer/pal=P3XEFFBFUFKN6

----- Original Message -----
From: <SyckoJayy@aol.com>
To: <shotimes@autox.team.net>
Sent: Sunday, December 22, 2002 10:46 AM
Subject: [Shotimes] Strange noise...help!


> Hey all,
>
>          I am posting for a friend who just recently bought a sho and isnt
> having very good luck with it.  Its a 95 atx with 67k on it, he just
replaced
> the water pump and thermostat and had the tranny fluid changed.  The car
was
> bought in Fl and then driven back here to northeast pa.  Stopped and
idling
> the oil light will flicker....after about 5-10 min of driving it will
start
> making a weird sound from the top end.  Its not a knock or a tick, it
almost
> sounds like a plastic sound and gets faster and more obscene when you rev
the
> engine.....could it be a loose or broken shim?....rod
> bearing?....valve?.....the engine has no loss of power just sounds really
> bad....any ideas?
>
> Thanks in advance
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes