[Shotimes] Strange noise...help!

[Ron Porter]

Well, the noise comes from all over, plus you can hear it in the car. Much
like any noise, it always sounds like it's coming from the top of the motor
until you check it out more closely.

Not sure that a motor getting hot will give you a rod noise from clearances
getting too tight, the bad-bearing noise is when they are too loose.
Detonation/pinging can be from being too hot. Maybe a cavitating water pump
from trying to pump air?

Ron Porter

-----Original Message-----
From: Ian Fisher [mailto:ianf@eden.rutgers.edu]
Sent: Sunday, December 22, 2002 12:43 PM
To: 'Ron Porter'; 'Paul L Fisher'; SyckoJayy@aol.com;
shotimes@autox.team.net
Subject: RE: [Shotimes] Strange noise...help!


Rod bearing noise has often been reported as resonating as if the noise
was coming from the top of the motor.
My theory; when the t-stat and water pump were replaced, the coolant
wasn't properly refilled and the t-stat might be stuck (air in the
system). The motor is overheating after running after a few minutes and
the bearing clearances are getting tight. It happened to me, but I
decided to add coolant to the rad instead of the overflow (duh) and
start it up and take it for a cool down drive when I felt it was safe to
do so. No more bearing noise since.

Ian


-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net] On Behalf Of Ron Porter
Sent: Sunday, December 22, 2002 12:19 PM
To: Paul L Fisher; SyckoJayy@aol.com; shotimes@autox.team.net
Subject: RE: [Shotimes] Strange noise...help!


Well, my bearings were TOAST at 86K:
http://www.picturetrail.com/gallery/view?p=999&gid=1097730&uid=168194

But, mine's also a 5-speed. Ian mentioned the bearings, but I dunno
about that, as bearings start making noise right off the bat, not after
5-10 minutes of driving.

Oil light flicker could also be from a slightly-too-low idle. Off the
top of my head, could the "new" water pump be acting up? Maybe after
getting hot, the blades are hitting the housing. I wouldn't suspect
anything in the top of the engine, as the clearances close up when it
gets hot.

Ron Porter



-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net]On Behalf Of Paul L Fisher
Sent: Sunday, December 22, 2002 11:58 AM
To: SyckoJayy@aol.com; shotimes@autox.team.net
Subject: Re: [Shotimes] Strange noise...help!


Without the noise, I would suggest it is the oil pressure sensor. I
would change that 1st anyhow. 67K miles is low for a rod knock. Mine
didn't start until 165K or so and only under certain situations.

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 167K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back,
Holley 190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar,
Performance-Plus Stainless Steel Y-pipe, Delrin sub-frame bushings,
Amsoil Series 2000 0W-30 oil, Amsoil Synthetic ATF. '00 Ford Explorer
XLT 5.0L V8 AWD Oxford White Clearcoat 34K Build date 11/19/1999
- Amsoil Series 2000 0W-30 oil, K&N Fuel Injection Performance Kit

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm

Get $5 free from Paypal! https://www.paypal.com/refer/pal=P3XEFFBFUFKN6

----- Original Message -----
From: <SyckoJayy@aol.com>
To: <shotimes@autox.team.net>
Sent: Sunday, December 22, 2002 10:46 AM
Subject: [Shotimes] Strange noise...help!


> Hey all,
>
>          I am posting for a friend who just recently bought a sho and
> isnt having very good luck with it.  Its a 95 atx with 67k on it, he
> just
replaced
> the water pump and thermostat and had the tranny fluid changed.  The
> car
was
> bought in Fl and then driven back here to northeast pa.  Stopped and
idling
> the oil light will flicker....after about 5-10 min of driving it will
start
> making a weird sound from the top end.  Its not a knock or a tick, it
almost
> sounds like a plastic sound and gets faster and more obscene when you
> rev
the
> engine.....could it be a loose or broken shim?....rod
> bearing?....valve?.....the engine has no loss of power just sounds
> really bad....any ideas?
>
> Thanks in advance _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net http://www.team.net/mailman/listinfo/shotimes