[Shotimes] Bulbs behind speedo

Tony Fratzke tfratzke@hotpop.com
Tue, 31 Dec 2002 15:58:55 -0600


Thank you!

Tony 93 ATX
----- Original Message -----
From: "Ron Porter" <ronporter@prodigy.net>
To: "Tony Fratzke" <tfratzke@hotpop.com>; "SHOTiimes"
<shotimes@autox.team.net>
Sent: Monday, December 30, 2002 9:00 PM
Subject: RE: [Shotimes] Bulbs behind speedo


> You might check the SHOtimes FAQ, as there may be something there. I wrote
> up something awhile back, but it's not in the personal archives. The
Cliff's
> Notes version is:
>
> 1. Remove kick plate under steering wheel to get to the lower 2 bolts of
the
> bezel, and remove them.
>
> 2. Remove top two bezel bolts by the speedo.
>
> 3. At this point, the whole bezel can be snapped out. Probably need to
> unclip a couple of the accessory wires to get the bezel out of the way.
>
> 4. Remove 4 screws that hold the IP to the dash. IIRC, the bigger screws,
> not all of the tiny ones.
>
> 5. Under the hood, pull the clip to disconnect the two halves of the
speedo
> cable (down below the m/c), and pull out the top section. This helps you
get
> the IP forward enough to unclip the speedo at the rear (unless you have
very
> thin, long fingers!!)
>
> 6. With the cable loosened, the IP can be pulled forward enough to
> disconnect the speedo cable clip at the IP (clip release lever is toward
the
> passenger side, IIRC)
>
> 7. IP can then be pulled forward enough to see ALL of the bulbs screwed
into
> the back of it. AutoZone carries the bulbs. The size is listed in the
owners
> manual (I forget offhand.....#37 maybe??).
>
> Not hard to do, after the first time, you can get it apart in 10-15
minutes.
>
> Ron Porter
>
> -----Original Message-----
> From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net]On Behalf Of Tony Fratzke
> Sent: Monday, December 30, 2002 8:04 PM
> To: SHOTiimes
> Subject: [Shotimes] Bulbs behind speedo
>
>
> I have a burned out buld behind my speedo. how ahard are these to replace?
> should i replace all of them at the same time? anyone have procedure for
> this
> job?
> Thanks!
> Tony 93 ATX
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes